Need something specific? Try our Advanced Search

Hit enter to search or ESC to close

we engineer light

show filters

Ceiling and Wall Bulkhead Lights

We have a wide range of quality bulkheads - for both ceiling and wall mounting - in a variety of finishes. Browse our range of Bulkhead Lights below...

reset filters close-circle Created with Sketch.
CATEGORY chevron-right Created with Sketch.
FINISHES chevron-right Created with Sketch.
MOUNTING TYPE chevron-right Created with Sketch.
INDOOR / OUTDOOR chevron-right Created with Sketch.
IP RATING chevron-right Created with Sketch.
POWER TYPE chevron-right Created with Sketch.
TECHNOLOGY chevron-right Created with Sketch.
COLOUR TEMPERATURE chevron-right Created with Sketch.
NUMBER OF LAMPS chevron-right Created with Sketch.
LAMP INCLUDED chevron-right Created with Sketch.
BEAM ANGLE chevron-right Created with Sketch.
HOLE CUT (MM) chevron-right Created with Sketch.
DOWNLIGHT CLASSIFICATION chevron-right Created with Sketch.
BUILDING CAVITY DEPTH chevron-right Created with Sketch.

Choosing Outdoor Luminare Materials & Finishes 

 

Polycarbonate and other Thermoplastic Fixtures

These are the nearest thing to the “Ideal” of everlasting and Maintenance free. Polycarbonate fixtures can be quite robust, but many thermoplastic fixtures are not as vandal-proof in public areas as their metal equivalent.

Aluminium Fixtures

These can be purchased in low-cost or expensive quality. Expensive fixtures are made of pure Aluminium and go through extensive pre-treatment and paint processes. The lower cost products need more care and maintenance to remove contaminants. Both product and maintenance costs have to be part of a balanced purchasing decision, few people like the “Flaking Paint” look. Take care not to scratch or chip the paint finish when handling and installing. It is highly recommended that outdoor lighting fixtures are not installed until the building project, landscaping and finishing are complete. If earlier installation is unavoidable ensure that fixtures are carefully wrapped and masked after installation. Painted fixtures should be washed with soapy water regularly, the maintenance period will be extended if a car wax is applied.

Installation

Wall mounted fixtures should have sealant applied along top and sides of fixtures mounting base.

Bare Metal Finishes, Stainless Steel, Copper and Brass

These fittings usually have a thin coat of lacquer applied at the factory, this is a temporary protection to ensure a uniform finish at point of installation.

Some situations lend themselves to natural discolouration (e.g.) Browning of Copper and Stainless Steel or the Verdigris look on Brass. Such corrosive effects are surface conditions, not structural. A lot of Stainless Steel fixture owners however wish to maintain the attractive shiny finish of the bare metal as purchased.

 

Cleaning of Stainless Steel Fixtures

Outdoor Stainless Steel fittings can be a high maintenance option. Stainless Steel will not corrode with pure water alone, however dampness can cause corrosion like stains when there are contaminants on the steel. There are various grades of Stainless Steel designed to resist different types of contaminants. Superlux use grades that are most suitable for the vast variety of lighting installations. Contaminants can be sea air, garden/agricultural sprays, fertilisers, natural tree and plant materials, swimming pools and man-made pollutants. Where these pollutants wash off with rain in open areas, problems are less likely, but when bare metal fixtures are installed in sheltered or tree covered areas, corrosion staining is inevitable. In such situations, exposed to the seaside or othercontaminants, regular washing with soapy water is a must to maintain the shiny bare metal look. A car wax or a special steel rejuvenating polish can be applied to extend the maintenance period.